Bild 1 av 4
Nyhet
Drivaxel, framaxel höger Löbro 306716
Slut i lager
[object Object]4 350 kr
/st inkl moms
Lägg till i favoriter
Frakt:
Fri frakt
Artnr:
2080656
Originalnr:
Specifikationer
- Varumärke LÖBRO
- Helservad
- Modell
- Gkn automotive oe-technology 52°
- Vibration
- Med svängningsdämpare
- Längd (mm)
- 957
- Längd 2 (mm)
- 342
- Leddiameter hjulsida (mm)
- 84
- Leddiameter växellådssida (mm)
- 86
- Diameter tätningsring (mm)
- 62
- Dammskydd
- Med dammskydd
- Bultmått
- M24x1.5
- Yttre kuggning diff.sida
- 26
- Yttre kuggning hjulsida
- 29
- Allmän information
- Med lager
- Allmän information
- Med mutter
Generell produktinformation
The technical specifications of GKN SX joints comply with
the respective OE joint. Bending angle, torque and steering
geometry are unchanged. Only with SX joints from GKN
Automotive there are no structural changes. More information
at www.gknautomotive.com.The technical specifications of GKN SX joints comply with
the respective OE joint. Bending angle, torque and steering
geometry are unchanged. Only with SX joints from GKN
Automotive there are no structural changes. More information
at www.gknautomotive.com.Please observe the specific technical specifications for the
joint. Here, a bending angle greater than 50° is required!Please observe the specific technical specifications for the
joint. Here, a bending angle greater than 50° is required!
the respective OE joint. Bending angle, torque and steering
geometry are unchanged. Only with SX joints from GKN
Automotive there are no structural changes. More information
at www.gknautomotive.com.The technical specifications of GKN SX joints comply with
the respective OE joint. Bending angle, torque and steering
geometry are unchanged. Only with SX joints from GKN
Automotive there are no structural changes. More information
at www.gknautomotive.com.Please observe the specific technical specifications for the
joint. Here, a bending angle greater than 50° is required!Please observe the specific technical specifications for the
joint. Here, a bending angle greater than 50° is required!